DCME=0, TEIE=0, SSE=0, RIE=0, MPIE=0, TE=0, TIE=0, IDSEL=0, RE=0
Common Control Register 0
| RE | Receive Enable 0 (0): Serial reception is disabled 1 (1): Serial reception is enabled |
| TE | Transmit Enable 0 (0): Serial transmission is disabled 1 (1): Serial transmission is enabled |
| MPIE | Multi-Processor Interrupt Enable 0 (0): Non-Multi-Processor reception 1 (1): Multi -Processor reception When the data with the multi-processor bit set to 0 is received, the data is not read, and setting the status flags to 1 is disabled. When the data with the multiprocessor bit set to 1 is received, the MPIE bit is automatically cleared to 0, and non-multi-processor reception is resumed. If you want to continue receiving operation using the multiprocessor function, set this bit to 1 sufficiently earlier than receiving the STOP bit of the next received frame. (Consider the synchronization delay time.) |
| DCME | Data Compare Match Enable 0 (0): Address match function is disabled 1 (1): Address match function is enabled |
| IDSEL | ID frame select 0 (0): It’s always compared data in spite of the value of the MPB bit. 1 (1): It’s compared data when the MPB bit is 1 (ID frame) only. |
| RIE | Receive Interrupt Enable 0 (0): SCIn_RXI and SCIn_ERI interrupt requests are disabled 1 (1): SCIn_RXI and SCIn_ERI interrupt requests are enabled |
| TIE | Transmit Interrupt Enable 0 (0): SCIn_TXI interrupt request is disabled 1 (1): SCIn_TXI interrupt request is enabled |
| TEIE | Transmit End Interrupt Enable 0 (0): SCIn_TEI interrupt request is disabled 1 (1): SCIn_TEI interrupt request is enabled |
| SSE | SSn Pin Function Enable 0 (0): SSn pin function is disabled. 1 (1): SSn pin function is enabled. |